Blowgun Electronic sighting system

This new targeting system offers a fully adjustable red dot scoping system and mounting hardware. Fits all .40 caliber
blowguns. Improves accuracy with a red dot aiming point. Fully adjustable for windage and elevation.

INCLUDES: Electronic Red Dot Sighting System and Mounting hardware

IMPORTANT: Be sure your blowgun is
not loaded.

MOUNTING:

1. Loosen screws and fit the mount base onto the rails or Weaver rails.


2. Hold the pipe in natural shooting position and adjust the scope eye relief
   until achieving a full field of view.


3. Tighten locking screws to ensure a firm grip onto the pipe. Do not over tighten
   as you can cause damage to the pipe.

ZEROING:

1. Place a target at an appropriate distance.


2. Switch on the electronic dot, aim at the center of the target and fire a
   test shot.


3. If the dart hit the center of the target, the dot sight was zeroed.
   If it didn't, adjust the dot using the elevation and/or windage adjusters as
   follows:
   

   a. Vertical Adjustment (Elevation) - Turn the elevation adjustment
   knob clockwise to move the point of impact up and counterclockwise to move
   the point of impact down.

   b. Horizontal Adjustment (Windage) - Turn the windage adjustment knob
   clockwise to move the point of impact left and counterclockwise to move the
   point of impact right.

   
   
4. Keep adjusting and test-firing until the test shot hits the center of the
   target.